VisionStat Plus MA-BCKS-7.0 Manual do Utilizador descarregar pdf (Página 15)

VisionStat Plus Video Monitoring and Obstacle Detection Sensor System

Sensor Installation

1) The width of vehicles vary. It

is important to install the Sen-

sors at the appropriate dis-

tance and location along the

rear bumper or equivalent

(see Figure 23). Assuming

that the width of vehicle is L,

then the space between Sen-

sors is 1/4L (Sensors must be

mounted S1, S2, S3, S4,

from left to right).

 Sensors S1 and S4 should be

located approximately 1/8L

from either side of the vehi-

cle. S2 and S3 will be located 1/4L from S1 and S4.

 If the Sensors are mounted on a DOT type bumper, the Sensor locations are deter-

mined by the vehicle width (L), not the width of the bumper.

2) Sensors should be mounted at an absolute minimum of 16 inches (40cm) to 32 inch-

es (80cm) from the ground, (20 inches (50cm) is a good choice, if available). See

Alternate Sensors Mounting Locations, on page 18, for other options.

Fig 23: Typical Sensor Location & Distance

Sensor Installation (In-Bumper Flush Mount)

For vehicles equipped with a bumper that can accommodate the

Sensors, carefully drill a 25mm hole and insert the Rubber Jacket,

properly orientated “UP”, in the hole first. Then insert the Sensor,

again properly orientated “UP” (see Figure 24). Depending on the

thickness of the bumper and construction, the hole diameter may

need to be varied. The Rubber Jacket is designed to seat properly

into a 25mm hole with a 1/8 inch (3.2mm) thick metal bumper. If this

is not the case, the flanges on the Rubber Jacket must be taken into

consideration. It is suggested that a test hole be utilized to confirm a

proper fit.

Sensor Installation (Standard Metal Under Bumper Bracket)

Fig 24: UP

Installing the Under Bumper Mount

 With a drill bit (M5), make 2 holes spaced

2.1875 inches (2 3/16” or 55.6mm) apart in

the bumper or equivalent. They should be

set back no more than 0.6 inches (15mm)

from the front edge of the bumper. It is

recommended to always take your own

measurements to ensure proper installa-

tion.

 Attach the Sensors on the bumper or simi-

lar vehicle fixture (metal bar, etc.) with the

enclosed mounting hardware.

 Some bumpers may not be exactly parallel

to the ground. When needed, the Sensor’s

vertical angle can be adjusted by placing a

shim between the bracket and bumper.

 See Figure 26, Figure 27 and Figure 28 for

additional Information on Sensor configuration.

Fig 25: Under-bumper Assembly &

Mount for Standard Metal Bracket

Sensor

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Comentários a estes Manuais

Sem comentários

VisionStat Plus MA-BCKS-7.0 Manual do Utilizador Página 15

Comentários a estes Manuais